Hi Nicolayer,
pinout is correct, but issue was caused by drivers.
After pseudo Novathor USB Rom drivers installation, ID was detected correctly :
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.34, JTAG Manager Version: 1.48
Selected Custom Target: [NOVATHOR U8500, 1.80V, TAP0]
Connecting to the target...OK
Set I/O Voltage reads as 1.80V, TCK Frequency is 12 MHz
Following devices are found on the JTAG chain:
Device on TAP #0: ID = 0x4BA00477, IR Length = 0x05 bits
Device on TAP #1: ID = 0xFFFFFFCF, IR Length = 0x01 bits
Device on TAP #2: ID = 0xFFFFF7FF, IR Length = 0x01 bits
Device on TAP #3: ID = 0xBFFFFFFF, IR Length = 0x01 bits
Device on TAP #4: ID = 0xFFFFFFFF, IR Length = 0x01 bits
Device on TAP #5: ID = 0x000000FF, IR Length = 0x01 bits
Total IR length: 0x000A bits
Analizing IDCODE(s) of the JTAG scan chain:
1. 0x4BA00477: Samsung S5PV300
2. 0x4BA00477: NovaThor U8500
3. 0x4BA00477: Generic CORTEX-A9
OOpen serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.34, JTAG Manager Version: 1.48
Selected Resurrector: [Samsung I9070 V1.0.4705.16773]
Connecting to the dead body...OK
Detected dead body ID: 0x4BA00477 - CORRECT!
Set I/O Voltage reads as 1.79V, TCK Frequency is 12 MHz
Settings Code: 0x00000E00000000000000000008000000
Resurrection sequence started.
Establish communication with the phone...OK
Initializing internal hardware configuration...OK
Uploading resurrector data into memory...FAILED
ERROR: RAM memory selftest failed.
Open serial port...OK
Connecting to the RIFF Box...OK
Firmware Version: 1.34, JTAG Manager Version: 1.48
Selected Custom Target: [NOVATHOR U8500, 1.80V, TAP0]
Connecting to the NOVATHOR U8500 target...OK
Detected Target ID on TAP0: 0x4BA00477
Set I/O Voltage reads as 1.79V, TCK Frequency is 12 MHz
Settings Code: 0x00000E00000000000000000008000000
Resurrection sequence started.
Establish communication with the phone...OK
Uploading loader data into memory...FAILED
ERROR: Memory at given address cannot be Written.